Silver Content

Silver in US Coins Before 1964 and the Switch to Clad

Which US coins contain silver, how much each denomination holds, why the Mint switched to clad in 1965, and how to tell a silver coin from a clad one.

On this page
  1. The Short Answer: Which US Coins Contain Silver
  2. Silver Content by Denomination
  3. The Partial-Silver Exceptions
  4. Why the US Stopped Using Silver
  5. What US Clad Coins Are Made Of
  6. How to Tell Whether an Old US Coin Is Silver
  7. What “Constitutional Silver” and “Junk Silver” Mean
  8. Modern US Coins That Still Contain Silver
  9. Silver Value vs. Collector Value
  10. Where to Go Next in This Section

The Short Answer: Which US Coins Contain Silver

US dimes, quarters and half dollars dated 1964 or earlier are 90% silver and 10% copper. So are the classic silver dollars, the Morgan and the Peace, which were last struck in 1935. In 1965 the US Mint stopped putting silver in circulating dimes and quarters and switched to the copper-nickel “clad” coins that still circulate today.

There are a few exceptions:

  • Jefferson “war nickels” struck from late 1942 through 1945 contain 35% silver.
  • Kennedy half dollars dated 1965 through 1970 contain 40% silver.
  • Some collector-only coins made after 1964 contain silver, but they were never released into general circulation.

This page is the hub for our silver content section. Below you’ll find silver weights by denomination, the history of the switch, what clad coins are made of, and practical ways to check a coin you’re holding.

Silver Content by Denomination

All 90% silver dimes, quarters and half dollars were made to the same standard, so their silver content is proportional to face value. Freshly struck, $1 in face value of any of the three holds about 0.7234 troy ounces of pure silver. Silver dollars hold slightly more per dollar of face value.

Denomination Main 20th-century series Fineness Gross weight Pure silver (troy oz)
Dime Barber, Mercury, Roosevelt (through 1964) 90% 2.50 g 0.07234
Quarter Barber, Standing Liberty, Washington (through 1964) 90% 6.25 g 0.18084
Half dollar Barber, Walking Liberty, Franklin, 1964 Kennedy 90% 12.50 g 0.36169
Dollar Morgan, Peace 90% 26.73 g 0.77344

These are the weights for coins as struck. Circulated coins have lost a little metal to wear. That’s why dealers usually price worn 90% dimes, quarters and halves at about 0.715 troy ounces per $1 face value rather than the full 0.7234. Our junk silver value guide shows how that conversion is used in practice.

Dimes

Barber dimes (1892-1916), Mercury dimes (1916-1945) and Roosevelt dimes from 1946 through 1964 are all 90% silver. Roosevelt dimes dated 1965 or later are clad. The exceptions are certain collector issues, covered further down.

Quarters

Barber quarters (1892-1916), Standing Liberty quarters (1916-1930) and Washington quarters from 1932 through 1964 are 90% silver. No quarters were struck for circulation in 1931. Washington quarters from 1965 on are clad.

Half Dollars

Barber halves (1892-1915), Walking Liberty halves (1916-1947), Franklin halves (1948-1963) and the 1964 Kennedy half are 90% silver. The half dollar is the denomination with an in-between period: from 1965 through 1970 it was made in 40% silver before going fully clad in 1971.

Silver Dollars

Morgan dollars (1878-1904 and 1921) and Peace dollars (1921-1928 and 1934-1935) are 90% silver. No silver dollars were struck for circulation after 1935. The Eisenhower dollar that followed in 1971 was clad for circulation.

Earlier Coinage

Silver coins from the 1800s, such as the Seated Liberty and Bust series, also contain silver. Their standards differed slightly in the early decades (for example, coins struck before 1837 used a fineness a little under 90%). Coins this old are usually valued as collectibles first and silver second. If you have them, it’s worth having them looked at individually rather than treating them as bullion.

The Partial-Silver Exceptions

War Nickels, 1942-1945 (35%)

During World War II, nickel was needed for the war effort. From late 1942 through 1945 the Mint struck Jefferson nickels in an alloy of 56% copper, 35% silver and 9% manganese. You can spot these coins by a large mint mark above Monticello on the reverse, and it’s the first time a “P” mint mark appeared on a US coin. Each one holds about 0.05626 troy ounces of silver. See our dedicated guide to spotting silver war nickels, including the 1942 nickels that are not silver.

Kennedy Halves, 1965-1970 (40%)

When dimes and quarters went clad in 1965, the half dollar kept some silver. Kennedy halves dated 1965 through 1970 have outer layers of 80% silver bonded to a core of mostly copper. Overall they are 40% silver, about 0.1479 troy ounces per coin. The 1970-D was issued only in mint sets, not for circulation. Details, weights and values are in our article on 40% silver Kennedy halves.

Collector-Only 40% Silver Coins

The Mint also made 40% silver versions of some coins for collectors, sold in proof and uncirculated sets rather than released through banks. Examples include:

  • Eisenhower dollars with the San Francisco “S” mint mark, sold in special collector packaging from 1971 to 1974 and in the Bicentennial issue.
  • Bicentennial (1776-1976) quarters, halves and dollars in 40% silver, sold in three-coin collector sets.

Because these were not circulation strikes, finding one in pocket change is unlikely. It isn’t impossible, though, since collector coins sometimes get spent.

Why the US Stopped Using Silver

Rising Silver Prices and the Coin Shortage

By the early 1960s, the market price of silver was approaching the point where the silver in a coin would be worth more than its face value. Industrial demand for silver was growing, and the government’s silver stockpile was shrinking. At the same time, the country was dealing with a coin shortage. People and businesses were holding on to coins, and some were hoarding silver in anticipation of its rising value. Once a coin’s metal is worth more than its face value, it tends to disappear from circulation. That pattern is usually summed up as Gresham’s law: “bad money drives out good.”

The Coinage Act of 1965

The Coinage Act of 1965, signed by President Lyndon B. Johnson in July 1965, made the change official. It removed silver from the dime and quarter and replaced it with a clad composition. It also reduced the half dollar to 40% silver. To ease the shortage, the Mint kept striking some coins with a 1964 date well into 1965. That means a 1964-dated coin is not necessarily one made in 1964, but it is still 90% silver.

The 40% half dollar didn’t last long. Its silver still made it worth hoarding, and few circulated widely. It was replaced by a fully clad half dollar in 1971.

What US Clad Coins Are Made Of

A clad coin is a “sandwich.” It has a core of one metal bonded between outer layers of another. US clad dimes, quarters and half dollars from 1965 (1971 for the half dollar) onward have outer layers of 75% copper and 25% nickel bonded to a core of pure copper. That’s why you can see a copper-colored stripe on the edge.

Coin Composition Weight
Dime (1965-present) Copper-nickel clad over pure copper core 2.268 g
Quarter (1965-present) Copper-nickel clad over pure copper core 5.670 g
Half dollar (1971-present) Copper-nickel clad over pure copper core 11.34 g
Eisenhower and Susan B. Anthony dollars Copper-nickel clad over pure copper core varies by coin
Small dollars, 2000-present (Sacagawea, Presidential, Native American) Manganese-brass clad over pure copper core 8.1 g

The five-cent nickel is not a clad coin. Outside the war years it has been a solid alloy of 75% copper and 25% nickel. The cent has been copper-plated zinc since 1982.

How to Tell Whether an Old US Coin Is Silver

You can sort most US coins in a few seconds without any special tools:

  1. Check the date. For dimes, quarters and halves, 1964 or earlier means 90% silver. A 1965-1970 half means 40%. A 1942-1945 nickel with a large mint mark above Monticello means 35%.
  2. Look at the edge. Clad coins show a distinct copper stripe on the edge. A 90% silver coin has a solid silvery-gray edge. A 40% Kennedy half has a mostly silvery edge with a faint darker line, but no bright copper band.
  3. Weigh it. A digital scale that reads to 0.01 g separates silver from clad easily. A silver quarter is about 6.25 g and a clad quarter about 5.67 g. A silver dime is 2.50 g and a clad dime about 2.27 g.
  4. Listen to it. Dropped gently on a hard surface, or tapped, silver coins tend to give a brighter, longer ring than clad coins. That’s a useful extra check, but don’t rely on it alone.

Weighing also helps catch rare transitional errors. A small number of 1965-dated dimes and quarters were accidentally struck on leftover silver planchets. A 1965 quarter that weighs about 6.25 g rather than 5.67 g deserves a closer look from an expert.

Counterfeits of common junk silver are not widespread, but fakes of silver dollars and bullion coins are. If you are buying rather than sorting pocket change, read our guide to testing for fake silver coins.

What “Constitutional Silver” and “Junk Silver” Mean

Junk silver is a dealer term for common, circulated silver coins that are valued mainly for their metal rather than their rarity. “Junk” refers to the lack of collector premium, not the quality of the silver.

Constitutional silver usually means the same 90% US dimes, quarters, halves and dollars made before 1965. The name nods to the early silver coinage standards set by Congress under its constitutional power to coin money. Some dealers also include war nickels and 40% halves under the term, so ask exactly what’s in a lot before buying.

Modern US Coins That Still Contain Silver

After 1964, silver moved out of circulating coinage and into collector and bullion products. Some examples:

  • Silver proof sets. These have contained 90% silver dimes, quarters and halves since 1992, and the Mint switched them to .999 fine silver starting in 2019. These coins share designs with clad coins but are sold only to collectors.
  • Commemorative silver dollars. Most modern US commemorative silver dollars are 90% silver. Recent issues have been .999 fine.
  • American Silver Eagles. These bullion coins have been made since 1986 and each contains one troy ounce of .999 fine silver.

If you’re comparing fineness markings like .900, .925 and .999, our explainer on whether 925 or 999 silver is purer covers how the standards compare.

Silver Value vs. Collector Value

For most worn, common-date silver coins, value tracks the price of silver. You can estimate melt value by multiplying the coin’s pure silver weight by the current spot price. Dealers then buy slightly below and sell slightly above that figure.

Some coins are worth far more than melt, though. Key dates, low-mintage issues, scarce mint marks, varieties and coins in high grade can carry large collector premiums. Before selling a group of old silver coins by weight, it’s worth checking dates and mint marks against a price guide, or having a knowledgeable dealer look through them.

Where to Go Next in This Section

Keep exploring

Guides from other topics

All topics →